![]() Insert the metal hex end of the Orbit key into the distance adjustment socket. Space adjacent heads for overlapping head-to-head coverage.Note: Do not use pipe dope on the threads. When the water is turned on, the sprinkler turret will begin to rotate toward the left stop. When the threads are snug, visually orient the arrow on top of the cap so that it points at the right stop by turning the entire sprin kler head on the riser. ![]() Select and install a riser height so the sprinkler spray Avill clear surrounding vegetation. When the sprinkler is buried the cap should be flush wiith the finish grade. Select and install a riser to obtain the proper height. Complete steps 1 and 2 under 'Pre-Set the Rotation".Turn the water on to thoroughly flush the lines of dirt and debris before installing any sprinkler heads.When the minimum arc (40°) is reached, the key will stop turning or there will be a ratcheting noise.While holding the nozzle turret at the right stop, turn the key counterclockwise- Each full turn of the key decreases the arc 90°.Insert the plastic end of the Orbit key into the pattern adjustment socket.When the arc (360°) is reached, the key stop turning or there will be a ratcheting noise.Each full turn of the key increases the arc 90° While holding the nozzle turret at the right stop, turn the key clockwise.Insert the plastic end of the Orbit key (Model 55070) into the pattern adjustment socket (See Figures 2 & 5.).The nozzle turret must be held in this position for all arc adjustments Rotate the nozzle turret clockwise to the right stop.Using the palm of you hand, rotate the nozzle turret counterclockwise to the left stop to complete any interrupted rotation cycle.It is recommended that initial adjustment be made before installation. Sprinklers may be adjusted with water on or off. Voyager Il sprinklers are preset to rotate approximately 180°. Set of 7 low-angle nozzles available (Model 55072, sold separately).Detailed installation instructions inside.Set of 12 interchangeable nozzles included.Comes with pre-installed, Standard #7 nozzle.40°-360° adjustable arc for fast, hassle-free adjustment, wet or dry.Replaces or works with most types of impact or gear drive sprinkler systems including Hunter, Toro Rainbird.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |